Other • PtokaX

Help me solve this problem on my Raspberry Pi 5.
I used PtokaX version 0.5.1.0 on a Raspberry Pi 3 with raspios-buster, and everything worked perfectly.
After purchasing a Raspberry Pi 5 with raspios-Trixie 64, I can't run Direct Connect Hub. I followed the instructions, but it still doesn't work. PtokaX version 0.5.3.0 also doesn't work on raspios-Trixie 64.
I'll add that I built the server using the following commands:

sudo apt-get install make g++ zlib1g-dev libtinyxml-dev
sudo apt-get install liblua5.1-dev
wget http://www.ptokax.org/files/0.5.1.0-nix-src.tgz
tar xzvf 0.5.1.0-nix-src.tgz
cd PtokaX
wget http://downloads.sourceforge.net/projec ... 6_2.tar.gz
tar -xf tinyxml_2_6_2.tar.gz
cd tinyxml
make
cd ..
make
Then I edited the Settings.xml file, entered my own settings, and everything worked.

This was done on a Raspberry Pi 3 with the raspios-buster operating system, and everything worked.
The same steps don't work on a Raspberry Pi 5 with raspios-Trixie 64.
Please help me solve this problem with my Raspberry Pi 5 16GB single-board computer with raspios-Trixie 64.

Statistics: Posted by KKND — Thu Feb 05, 2026 1:07 pm — Replies 1 — Views 63

---