Other • Orca Slicer (3D Printers)

I've installed Orca Slicer as an App Image (OrcaSlicer-2.3.1-arm64-linux.AppImage) It works OK but I can't resize the main window which is a bit small unless I maximise it and then I can't un-maximise it, only close it. If I run it from a terminal then I see lots of Gtk errors like this:
(orca-slicer:49587): Gtk-CRITICAL **: 23:36:56.264: gtk_window_resize: assertion 'height > 0' failed

Is there a way of fixing this or should I install the FlatPak version instead?

Statistics: Posted by pettefar — Thu Nov 06, 2025 11:52 pm — Replies 0 — Views 45

---