Hello Raspberry Pi Enthusiasts,
I've directly connected a Hi-Link HLK-LD2450 motion tracking module to my Raspberry Pi via a cable, and I'm trying to figure out how to intercept its signal to display the data in the terminal.
This module is designed to track motion and I assume it should transmit data directly to the Raspberry Pi through the connected cable. However, I'm at a loss on how to receive this data. I'm not privy to the module's documentation, so I'm uncertain about the data transmission protocol it employs (whether it's HTTP, TCP, UDP, etc.), and I don't know the IP address or the port it uses for communication.
I'm seeking advice on how to detect the signal from this module. What tools or commands can I use on my Raspberry Pi to capture and display this direct cable signal? Any suggestions or directions would be greatly appreciated.
Please see the attached photo of the module.
Thank you for your help!
https://github.com/csRon/HLK-LD2450
I've directly connected a Hi-Link HLK-LD2450 motion tracking module to my Raspberry Pi via a cable, and I'm trying to figure out how to intercept its signal to display the data in the terminal.
This module is designed to track motion and I assume it should transmit data directly to the Raspberry Pi through the connected cable. However, I'm at a loss on how to receive this data. I'm not privy to the module's documentation, so I'm uncertain about the data transmission protocol it employs (whether it's HTTP, TCP, UDP, etc.), and I don't know the IP address or the port it uses for communication.
I'm seeking advice on how to detect the signal from this module. What tools or commands can I use on my Raspberry Pi to capture and display this direct cable signal? Any suggestions or directions would be greatly appreciated.
Please see the attached photo of the module.
Thank you for your help!
https://github.com/csRon/HLK-LD2450
Statistics: Posted by karetnik — Mon Mar 25, 2024 3:51 pm — Replies 1 — Views 85