Hi,
I have used config file to create overlay for new ic2 bus 2 and it works fine with pca9685 servo but when I try and use my time of flight sensor VL53L5CX it can find hex 029. But when I do detect it shows fine . My theory is that the software is defaulting to bus 1 but I can’t find where this would be.
Anybody know how to point vl53l5cx at the new bus ?
Getting desperate now and wife is getting cross with the me for spending far to long on the Pi !!
Cheers
Steve
I have used config file to create overlay for new ic2 bus 2 and it works fine with pca9685 servo but when I try and use my time of flight sensor VL53L5CX it can find hex 029. But when I do detect it shows fine . My theory is that the software is defaulting to bus 1 but I can’t find where this would be.
Anybody know how to point vl53l5cx at the new bus ?
Getting desperate now and wife is getting cross with the me for spending far to long on the Pi !!
Cheers
Steve
Statistics: Posted by TheStigDuke — Sat Aug 30, 2025 10:19 am — Replies 0 — Views 58