Hello,
I built a new cnc, I have a c-10 board and Bipolar Stepper Motor Driver, 40VDC/3A with Nema 23 Stepper Motor (https://www.oyostepper.com/category-7-b ... Motor.html), in mach3, I have it all wired up, mach 3 is programmed in ports and pins, no movement when I tried slow start, turned on motor lock and that's it, I double checked the wiring and everything looks ok, I put a jumper on the EN pin but no movement, does anyone have any ideas?
I'm lost and don't know where to start.
Thanks
I built a new cnc, I have a c-10 board and Bipolar Stepper Motor Driver, 40VDC/3A with Nema 23 Stepper Motor (https://www.oyostepper.com/category-7-b ... Motor.html), in mach3, I have it all wired up, mach 3 is programmed in ports and pins, no movement when I tried slow start, turned on motor lock and that's it, I double checked the wiring and everything looks ok, I put a jumper on the EN pin but no movement, does anyone have any ideas?
I'm lost and don't know where to start.
Thanks
Statistics: Posted by Karen24 — Thu Jun 19, 2025 6:09 am — Replies 0 — Views 11